Polycom DMA 7000 Operation Manual page 54

DMA Operations Guide
46
Table 4-4 Fields on the Signaling Configuration page (continued)
Field
Register to gatekeeper
Status
Primary gatekeeper IP
address or host name
Secondary gatekeeper
IP address or host
name
Gatekeeper type
SIP Settings
Enable SIP signaling
Unencrypted SIP port
TLS port
Description
Enables the gatekeeper fields below.
Status of gatekeeper registration.
IP address or host name of gatekeeper.
IP address or host name of the secondary or backup
gatekeeper. Optional.
Used only when the primary is not available during
startup or when the alternate designated by the primary
gatekeeper is not available.
Leave the default, Polycom, for a Polycom Converged
Management Application™ (CMA™), PathNavigator™,
or ReadiManager® SE200 gatekeeper. Select Other for
a Cisco Multimedia Conference Manager (MCM),
Tandberg Video Communications Server (VCS), or
other gatekeeper.
Enables the system to receive Session Initiation
Protocol (SIP) calls.
Note: Disabling SIP terminates any existing SIP calls.
When you click Update, the system prompts you to
confirm.
If Security Configuration
SIP connections, you can select either TCP or
UDP/TCP from the list.
We recommend using the default port number (5060),
but you can use any value from 1024 to 65535 that's not
already in use and is different from the TLS port.
Specifies the port number the system uses for TLS.
We recommend using the default port number (5061),
but you can use any value from 1024 to 65535 that's not
already in use and is different from the UDP/TCP port.
If SIP signaling is enabled, TLS is automatically
supported. Unless unencrypted SIP connections are
specifically permitted, TLS must be used. See
Configuration" on page 32.
Signaling Configuration
settings permit unencrypted
"Security
Polycom, Inc.