Polycom DMA 7000 Operation Manual page 39

Certificate Procedures
Polycom, Inc.
Both procedures are described below.
Caution
Installing or removing certificates requires a system restart and terminates all active
conferences.
When you install or remove a certificate, the change is made to the certificate store
immediately, but the system can't implement the change until it restarts and reads
the changed certificate store.
For your convenience, you're not required to restart and apply a change
immediately. This permits you to perform multiple installs or removals before
restarting and applying the changes. But when you're finished making changes, you
must select Restart to Apply Saved Changes to restart the system and finish your
update. Before you begin, make sure there are no active conferences and you're
prepared to restart the system when you're finished.
To remove a Trusted Root CA's certificate
Go to Configuration > System > Certificate Management.
1
In the certificates list, select the certificate you want to delete.
2
In the Actions list, select Display Details and confirm that you've
3
selected the correct certificate. Then click OK.
In the Actions list, select Delete Certificate.
4
When asked to confirm, click Yes.
5
A dialog box informs you that the certificate has been deleted.
Click OK.
6
Click Restart to Apply Saved Changes, and when asked to confirm that
7
you want to restart the system so that certificate changes can take effect,
click OK.
To remove a signed certificate and revert to the default self-signed certificate
Go to Configuration > System > Certificate Management.
1
In the Actions list, select Revert to Default Certificate.
2
When asked to confirm, click Yes.
3
A dialog box informs you that the system has reverted to a self-signed
certificate.
Click OK.
4
Click Restart to Apply Saved Changes, and when asked to confirm that
5
you want to restart the system so that certificate changes can take effect,
click OK.
System Security
31