Polycom DMA 7000 Operation Manual page 91

Conference Templates
Polycom, Inc.
Table 6-2 Add Conference Template dialog box (continued)
Field
Content settings
Content protocol
RMX Video Settings
Presentation mode
Send content to legacy
endpoints
Same layout
Lecturer view switching
Auto layout
Description
The transmission mode for the Content channel:
• Graphics — lowest bit rate for basic graphics
• High-resolution graphics — higher bit rate for better
graphics resolution
• Live video — the Content channel is used for live
video
A higher bit rate for the Content channel reduces the bit
rate for the People channel.
Content channel protocol options:
• Use H.264 if available, otherwise use H.263.
• Always use H.263.
Enables a conference to change to lecture mode when
the current speaker speaks for 30 seconds. When
another participant starts talking, it returns to the
previous video layout.
Not available if Video switching or Same layout is
selected, or if Telepresence mode is Yes.
Enables endpoints that don't support H.239 to receive
the Content channel over the video (People) channel.
Available only on MCUs with MPM+ and MPMx cards.
Not available if Video switching or Same layout is
selected, or if Telepresence mode is Yes.
Forces the selected layout on all participants. Personal
selection of the video layout is disabled.
Not available if Presentation mode or Video switching
is selected, or if Telepresence mode is Yes.
When in lecture mode, enables the lecturer's view to
automatically switch among participants (if the number
exceeds the number of windows in the layout) while the
lecturer is talking.
Not available if Same layout is selected or
Telepresence mode is Yes.
Lets the system select the video layout based on the
number of participants in conference. Clear the check
box to select a specific layout (below).
Not available if Video switching is selected or
Telepresence mode is Yes.
Conference Setup
83