Ducati MONSTER 821 Workshop Manual page 619

procedure.
Insert spring stopper (13) into the hole (A) of the rear RH footpeg holder plate (6) as shown. If necessary,
smear pin (B) retaining spring (13) with recommended grease in order to keep it in the correct position.
Insert the spring (12) into the special hole of the footpeg (3).
Fit the ball (11) on the spring (12).
Fit the footpeg (3) to rear RH footpeg holder plate (6) fitting pin (9), positioning parts as shown.
Fasten pin using circlip (8).
If previously removed, refit the footpeg rubber block (7) and insert buffers (B) into the corresponding
grooves on footpeg (3), pressing until teeth on footpeg rubber block (7) snap beyond footpeg profile.
619 Ducati Manuals Resource