Refitting The Gearchange Mechanism - Ducati MONSTER 821 Workshop Manual

Refitting the gearchange mechanism

Position the gearbox drum selector fork in the centre of the gear rollers.
Position the gearchange mechanism (3) together with control shaft, spring and plate into the chain-side
crankcase half.
Insert the screws (1) and (2) with the spacer (4).
Temporarily fit gearchange lever (or a service lever) and engine sprocket and shift to neutral gear.
Set tool (A) part no. 88713.3334 on the gearbox pawl.
Place tool (A) part no. 88713.3334 inserting a service pin (E) into the tool hole, block the pin (F) of the
tool in the gear pawl pressing with the hand in the point (G) (pawl stroke stop plate) towards the right, as
shown in photo.
1038 Ducati Manuals Resource