Right-hand switch
In the event of a fault, the internal connections of the device must be checked in all operating conditions. It
is therefore necessary to disconnect the main wiring switch connector and perform the check using an
analogue or digital multimeter.
Note
The same test may be done using the "DDS 2" diagnosis instrument.
RIGHT-HAND SWITCH CONTROL
Remove the RH handgrip as described in chapter
"Removing the
handlebar".
Loosen screws (1) and remove the right-hand switch by disconnecting it from the main connection. 6_0105
The colours mentioned in the following descriptions refer to the colour of the wires from the switch and not
to the colour of the main electric system wires.
Electric diagram
CONTROLS ON RIGHT-HAND SWITCH
371
Ducati Manuals Resource