Ducati MONSTER 821 Workshop Manual page 781

Fit protection plugs on frame (Refitting structural components and
frame).
Connect the wiring connectors on the engine block (Routing of wiring on
frame).
Refit the front sprocket (Refitting the front
sprocket).
Refit the rear swinging arm (Refitting the rear swinging arm) complete with rear wheel and refit the braking
system (Refitting the rear brake
calliper).
Refit hoses (Routing wiring harnesses/hoses) and rear ABS braking system (Adjusting the phonic wheel sensor AIR-
GAP).
Connect the starter motor/solenoid starter cable (Refitting the starter
motor).
Refit the clutch cable lever on clutch cover (Refitting the clutch cover), by correctly repositioning wirings and
hoses (Routing of wiring on
frame).
Fit the electrical components compartment on engine (Refitting the electrical component compartment) and
reconnect wiring connectors (Routing of wiring on
frame).
Refit lower wiring cover, on the left side (Routing of wiring on
frame).
Refit the complete exhaust system (Refitting the exhaust
system, Refitting silencer).
Refit the side stand (Refitting the side
stand).
Refit the footrest holder plates (Refitting the footrest holder plate), complete with rear brake assembly and
gearchange lever assembly.
Reconnect coil and spark plug cables (Routing of wiring on
frame).
Refit the secondary air system pipes and valve (Refitting the secondary air
system).
781 Ducati Manuals Resource