Reassembling The Gearbox Assembly - Ducati MONSTER 821 Workshop Manual

Reassembling the gearbox assembly

To refit the gearbox components follow the procedure under chapter "Closing the crankcase" relating to the
reassembly of the crankcase.
As a final practical test, ensure that with the gearbox in neutral the front coupling dogs (A) of sliding gears
(B) are equidistant on both sides with respect to the corresponding coupling dogs on the fixed gears (C).
Check also that there is always a small amount of clearance between fork (D) and relative groove (E) on
sliding gear (B) when engaging the gears.
Close the crankcase halves (Closing the
crankcase).
Refit the primary drive gear (Refitting the primary drive gear and checking
backlash).
Refit the clutch unit (Refitting the
clutch).
Refit the clutch cover (Refitting the clutch
cover).
Refit the starter motor (Refitting the starter
motor).
Refit the complete generator (Fitting the flywheel/generator assembly) and the generator side cover (Fitting the
generator cover).
Refit the oil pump (Refitting the oil
pump).
Refit the complete cylinder/piston assembly (Refitting the cylinder/piston
assembly).
Refit the complete cylinder head assembly (Refitting the cylinder
heads).
1047 Ducati Manuals Resource