Removing The Rear Brake Calliper - Ducati MONSTER 821 Workshop Manual

Removing the rear brake calliper

Drain the rear braking system (Changing the rear brake system
fluid).
For the ABS brake system, please also refer to Sections "ABS system operation information" and chapters
"System components" and "ABS component maintenance".
Undo and remove the special screw (1) securing the hose (2) to the rear brake calliper and the
corresponding washers (3).
Remove the hose (2).
Undo the two fastening screws (4) securing the rear brake calliper (5) to the calliper holder bracket, and
remove the brake calliper (5).
If it is necessary to remove the calliper holder plate (A), refer to section "Removing the swinging
arm".
To replace the brake pads follow instructions in the paragraph "Checking brake pad wear and replacing rear brake
pads".
To remove the speed sensor (6), undo the fastening screw (7) paying attention to the spacer defining the
air-gap (8).
443 Ducati Manuals Resource