Disassembling The Generator Cover - Ducati MONSTER 821 Workshop Manual

Disassembling the generator cover

Undo the three stator retaining screws (13) and the retaining screws (14) of the cable guide bracket (15)
from inside the generator cover.
Remove the stator (16) and the cable guide bracket (15).
The generator cover is fitted with a bearing (17), held in place by the circlip (18), which is located on the
end of the crankshaft.
Remove the circlip (18) with suitable pliers.
Remove the bearing (17) using a universal puller.
Be careful when fitting the new bearing (17) to ensure it is positioned with the shielded side facing away
from the cover.
Secure the bearing with the circlip (18), ensuring that it is correctly fitted in its seat in the generator cover
(9).
When refitting stator, tighten the three screws (13) to a torque of 10 Nm (Min. 9 - Max. 11) and the screws
(14) to a torque of 5 Nm (Min. 4.5 Nm - Max. 5.5 Nm) after having applied the indicated product.
Loosen the unions (8) delivering water to the horizontal and vertical cylinder assemblies.
When fitting the new components, apply the recommended sealant and tighten to a torque of 25 Nm (Min.
23 Nm - Max. 27 Nm).
The unions (8) may also be removed without removing the generator cover (9) from the engine.
Remove the water pump components (A) (Removing the water
pump).
1089 Ducati Manuals Resource