Changing The Front Phonic Wheel Sensor - Ducati MONSTER 821 Workshop Manual

Changing the front phonic wheel sensor

Disconnect front ABS sensor (1) connector (A) from main wiring.
Open all clips retaining front ABS sensor cable (1): refer to tables under Section: "Routing wiring harnesses /
hoses".
Undo the retaining screw (2), and remove front ABS sensor (1) with calibrated gasket (3), sliding cable (4)
out from cable grommet.
Before refitting, make sure that contact parts between front ABS sensor (1) and its seat are free of damage
and perfectly clean. Fit the new front ABS sensor (1) on its seat inserting the screw (2).
Check air gap between front ABS sensor (1) and front phonic wheel (5) as explained under Section
"Adjusting the AIR-GAP of phonic wheel
sensor.".
Tighten the screw (2) to a torque of 7Nm ± 10%.
486 Ducati Manuals Resource