Refitting The Gear Change Control - Ducati MONSTER 821 Workshop Manual

Refitting the gear change control

Apply the threadlocker on shaft (1).
Install O-ring (3) onto shaft (1).
Grease screw collar (1) with the specified grease.
Insert the shaft (1) in the gear lever (2), and insert the other O-ring (3) and the washer (4).
Fit the gear lever on the footpeg holder plate by inserting and tightening the shaft (1) to the specified
torque of 23 Nm ± 10%.
Fit lever (7) on gear transmission rod assembly (8), starting screw (9).
Tighten the screw (9) to a torque of 10Nm ± 10%.
Fit the gear change unit inserting the lever (7) on the gear control pin, apply threadlocker on the screw (6)
and insert it on the lever (7).
Tighten the screw (6) to a torque of 10Nm ± 10%.
519 Ducati Manuals Resource