Fitting the generator cover
Before the assembly, make sure that the following parts are fitted on the generator cover (9):
the crankshaft bearing (17) with the circlip (18);
-
the generator stator (16) with cable locking bracket (15).
-
Tighten the three stator screws (13) to a torque of 10 Nm (Min. 9 Nm - Max. 11 Nm) after having applied
the indicated product.
Tighten the two screws (14) on bracket (15) to a torque of 5 Nm (Min. 4.5 Nm - Max. 5.5 Nm) after having
applied the indicated product.
Fit the water pump assembly
Remove any scale and grease from the mating surfaces of the left-hand crankcase half and the generator
cover.
Fit the two centring bushes (20).
Spread a continuous uniform bead of DUCATI sealing compound on the cover mating surface, and around
the holes for the screws and bushes.
(Refitting the water
pump).
1073
Ducati Manuals Resource