Apply the recommended threadlocker on shaft (5).
Fit brake lever (6) with spring (7) starting shaft (5).
Tighten shaft (5) to a torque of 24 Nm ± 10% after having applied the specified product.
Apply the specified threadlocker to screws (1).
Fit rear brake master cylinder (2) and stop sensor connector support bracket (16) on vehicle, starting
retaining screws (1) inside nuts (15).
Insert the rod (3) inside the master cylinder (2), after applying the recommended grease.
Tighten screws (1) to a torque of 10 Nm ± 10% after having applied the specified product.
447
Ducati Manuals Resource