Refitting the fuel tank flange
If breather cap (5) has been removed, apply the specified product in the two points (A), 180° one from the
other.
Fit breather cap (5) fully home in the fuel tank indicated hole.
Rotate the cap in the 1-2-3 sequence shown in the figure to evenly distribute the adhesive product
previously applied on the two points (A) of the lower profile:
1 - rotate cap (5) by approximately 90° clockwise;
2 - bring cap (5) back to its original position;
3 - rotate cap (5) by approximately 90° counter clockwise.
703
Ducati Manuals Resource