Refitting The Rear Brake Calliper - Ducati MONSTER 821 Workshop Manual

2015
Hide thumbs Also See for MONSTER 821:
Table of Contents

Advertisement

Refitting the rear brake calliper

If the brake lines are replaced or if one of the rear brake system components has been removed, make
sure that the hose unions on the master cylinder and the calliper are correctly positioned.
Warning
If incorrectly positioned, hoses can affect brake operation and foul moving parts. Position the component as
shown in the figure.
Remember to fit the copper gaskets (3) to the hose end union when reconnecting the brake line to the
brake calliper (5).
After having aimed the hose union, tighten special screw (1) with pre-applied threadlocker to the torque of
23 Nm ± 10%.
If the speed sensor (6) is removed, fit it to the calliper holder plate with the spacer (8), and tighten the
screw (7) to a torque of 7 Nm ± 10%.
Note
439
Ducati Manuals Resource

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents