Enabling Snmp Agent Status; Figure 3-25 Configuring Ip Trap Managers - Digisol DG-FS4526 Management Manual

3
Configuring the Switch
• Trap Version – Specifies whether to send notifications as SNMP v1, v2c, or v3
traps. (The default is version 1.)
• Trap Security Level – Specifies the security level.
• Enable Authentication Traps – Issues a trap message whenever an invalid
community string is submitted during the SNMP access authentication process.
(Default: Enabled)
• Enable Link-up and Link-down Traps – Issues a trap message whenever a port
link is established or broken. (Default: Enabled)
Web – Click SNMP, Configuration. Fill in the IP address and community string for
each trap manager that will receive trap messages, and then click Add. Select the
trap types required using the check boxes for Authentication and Link-up/down
traps, and then click Apply.
CLI – This example adds a trap manager and enables both authentication and
link-up, link-down traps.
Console(config)#snmp-server host 192.168.1.19 private version 2c
Console(config)#snmp-server enable traps

Enabling SNMP Agent Status

Enables SNMPv3 service for all management clients (i.e., versions 1, 2c, 3).
Command Attributes
• SNMP Agent Status – Check the box to enable or disable the SNMP Agent.
3-38

Figure 3-25 Configuring IP Trap Managers

www.digisol.com
4-137
4-139