Show Lldp Info Remote-Device - Digisol DG-FS4526 Management Manual

4
Command Line Interface

show lldp info remote-device

This command shows LLDP global and interface-specific configuration settings for
remote devices attached to an LLDP-enabled port.
Syntax
show lldp info remote-device [detail interface]
• detail - Shows detailed information.
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-26)
• port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec
Example
Console#show lldp info remote-device
LLDP Remote Devices Information
Interface | ChassisId
--------- + ----------------- ----------------- ---------------------
Eth 1/5 | 00-17-7C-0A-E2-F1 00-17-7C-0A-E2-F8
Console#show lldp info remote-device detail ethernet 1/5
LLDP Remote Devices Information Detail
---------------------------------------------------------------
Local PortName
Chassis Type
Chassis Id
PortID Type
PortID
SysName
SysDescr
PortDescr
SystemCapSupported : Bridge
SystemCapEnabled
Remote Management Address :
192.168.1.2 (IPv4)
Remote Port VID : 1
Remote VLAN Name :
VLAN-1 : DefaultVlan
VLAN-4093 :
Remote Protocol Identity (Hex) :
88-CC
Remote MAC/PHY configuration status :
Remote port auto-neg supported : Yes
Remote port auto-neg enabled : Yes
Remote port auto-neg advertised cap (Hex) : 6C00
Remote port MAU type : 16
4-198
PortId
: Eth 1/5
: MAC Address
: 00-17-7C-0A-E2-F1
: MAC Address
: 00-17-7C-0A-E2-F8
:
: DG-FS4552
: Ethernet Port on unit 1, port 7
: Bridge
www.digisol.com
SysName