Authentication Commands; Table 4-28 Authentication Commands - Digisol DG-FS4526 Management Manual

4
Command Line Interface
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or code image.
• unit* - Specifies the unit number. (Range: 1)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
Example
Console(config)#boot system config: startup
Console(config)#
Related Commands
dir (4-76)
whichboot (4-77)

Authentication Commands

You can configure this switch to authenticate users logging into the system for
management access using local or RADIUS authentication methods. You can also
enable port-based authentication for network client access using IEEE 802.1X.
Command Group
Authentication Sequence
RADIUS Client
TACACS+ Client
AAA
Port Security
Port Authentication
4-78

Table 4-28 Authentication Commands

Function
Defines logon authentication method and precedence
Configures settings for authentication via a RADIUS server
Configures settings for authentication via a TACACS+ server
Configures authentication, authorization, and accounting for
network access
Configures secure addresses for a port
Configures host authentication on specific ports using 802.1X
www.digisol.com
Page
4-79
4-81
4-85
4-88
4-97
4-99