Dot1X Default; Dot1X Max-Req - Digisol DG-FS4526 Management Manual

4
Command Line Interface
[no] dotx system-auth-control
Default Setting
Disabled
Command Mode
Global Configuration
Example
Console(config)#dot1x system-auth-control
Console(config)#

dot1x default

This command sets all configurable dot1x global and port settings to their default
values.
Command Mode
Global Configuration
Example
Console(config)#dot1x default
Console(config)#

dot1x max-req

This command sets the maximum number of times the switch port will retransmit an
EAP request/identity packet to the client before it times out the authentication
session. Use the no form to restore the default.
Syntax
dot1x max-req count
no dot1x max-req
count – The maximum number of requests (Range: 1-10)
Default
2
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x max-req 2
Console(config-if)#
4-100
www.digisol.com