Show Policy-Map Interface; Voice Vlan Commands - Digisol DG-FS4526 Management Manual

Example
Console#show policy-map
Policy Map rd_policy
class rd_class
set ip dscp 3
Console#show policy-map rd_policy class rd_class
Policy Map rd_policy
class rd_class
set ip dscp 3
Console#

show policy-map interface

This command displays the service policy assigned to the specified interface.
Syntax
show policy-map interface interface input
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-26)
• port-channel channel-id (Range: 1-12)
Command Mode
Privileged Exec
Example
Console#show policy-map interface ethernet 1/5
Service-policy rd_policy input
Console#

Voice VLAN Commands

The switch allows you to specify a Voice VLAN for the network and set a CoS priority
for the VoIP traffic. VoIP traffic can be detected on switch ports by using the source
MAC address of packets, or by using LLDP (IEEE 802.1AB) to discover connected
VoIP devices. When VoIP traffic is detected on a configured port, the switch
automatically assigns the port to the Voice VLAN. Alternatively, switch ports can be
manually configured.
Command
voice vlan
voice vlan aging
voice vlan mac-address
switchport voice vlan
switchport voice vlan rule
Table 4-74 Voice VLAN Commands
Function
Defines the Voice VLAN ID
Configures the aging time for Voice VLAN ports
Configures VoIP device MAC adresses
Sets the Voice VLAN port mode
Sets the automatic VoIP traffic detection method for ports IC
www.digisol.com
DG-FS4526 User Manual
Mode
GC
GC
GC
IC
4
Page
4-270
4-271
4-271
4-272
4-273
4-269