Mapping Cos Values To Acls; Figure 3-124 Mapping Cos Values To Acls - Digisol DG-FS4526 Management Manual

3
Configuring the Switch

Mapping CoS Values to ACLs

Use the ACL CoS Priority page to set the output queue for packets matching a
configured ACL rule. For information on configuring ACLs, see "Access Control
Lists" on page 3-89.
Command Usage
You must configure an ACL before you can map a CoS queue to the rule.
Command Attributes
• Port – Port identifier.
• Name – Name of a configured ACL.
• Type – Type of ACL (IP or MAC).
• CoS Priority – CoS queue used for packets matching the ACL rule. (Range: 0-3)
Web – Click Priority, ACL CoS Priority. Select a port and an ACL rule, then specify a
CoS queue. Click Add.
CLI – This example assigns the CoS queue 3 to packets matching rules within the
specified ACL on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#map access-list ip bill cos 3
Console(config-if)#
3-194

Figure 3-124 Mapping CoS Values to ACLs

www.digisol.com
4-150
4-257