Igmp Filtering And Throttling Commands; Ip Igmp Filter (Global Configuration) - Digisol DG-FS4526 Management Manual

4
Command Line Interface
Command Usage
Multicast router port types displayed include Static.
Example
The following shows that port 11 in VLAN 1 is attached to a multicast router:
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1
2
Console#

IGMP Filtering and Throttling Commands

In certain switch applications, the administrator may want to control the multicast
services that are available to end users. For example, an IP/TV service based on a
specific subscription plan. The IGMP filtering feature fulfills this requirement by
restricting access to specified multicast services on a switch port, and IGMP
throttling limits the number of simultaneous multicast groups a port can join.
Command
ip igmp filter
ip igmp profile
permit, deny
range
ip igmp filter
ip igmp max-groups
ip igmp max-groups action
show ip igmp filter
show ip igmp profile
show ip igmp throttle interface

ip igmp filter (Global Configuration)

This command globally enables IGMP filtering and throttling on the switch. Use the
no form to disable the feature.
4-286
Eth 1/11 Static
Eth 1/12 Static
Table 4-79 IGMP Filtering and Throttling Commands
Function
Enables IGMP filtering and throttling on the switch
Sets a profile number and enters IGMP filter profile
configuration mode
Sets a profile access mode to permit or deny
Specifies one or a range of multicast addresses for a
profile
Assigns an IGMP filter profile to an interface
Specifies an IGMP throttling number for an interface
Sets the IGMP throttling action for an interface
Displays the IGMP filtering status
Displays IGMP profiles and settings
Displays the IGMP throttling setting for interfaces
www.digisol.com
Mode Page
GC
4-28
6
GC
4-28
7
IPC
4-28
8
IPC
4-28
8
IC
4-28
9
IC
4-28
9
IC
4-29
0
PE
4-29
1
PE
4-29
1
PE
4-29
2