Configuring Vlan Interfaces; Interface Vlan - Digisol DG-FS4526 Management Manual

4
Command Line Interface
Example
The following example adds a VLAN, using VLAN ID 105 and name RD5. The VLAN
is activated by default.
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
Related Commands
show vlan (4-232)

Configuring VLAN Interfaces

Command

interface vlan

switchport mode
switchport
acceptable-frame-types
switchport ingress-filtering
switchport native vlan
switchport allowed vlan
switchport gvrp
switchport forbidden vlan
switchport priority default
interface vlan
This command enters interface configuration mode for VLANs, which is used to
configure VLAN parameters for a physical interface.
Syntax
interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4094, no leading zeroes)
Default Setting
None
Command Mode
Global Configuration
4-226
Table 4-61 Configuring VLAN Interfaces
Function
Enters interface configuration mode for a specified VLAN
Configures VLAN membership mode for an interface
Configures frame types to be accepted by an interface
Enables ingress filtering on an interface
Configures the PVID (native VLAN) of an interface
Configures the VLANs associated with an interface
Enables GVRP for an interface
Configures forbidden VLANs for an interface
Sets a port priority for incoming untagged frames
www.digisol.com
Mode Page
GC 4-226
IC 4-227
IC 4-228
IC 4-228
IC 4-229
IC 4-230
IC 4-222
IC 4-231
IC
4-24
8