Mvr (Global Configuration); Table 4-80 Multicast Vlan Registration Commands - Digisol DG-FS4526 Management Manual

tree for a normal multicast VLAN. Also note that MVR maintains the user isolation
and data security provided by VLAN segregation by passing only multicast traffic
into other VLANs to which the subscribers belong.
Command
mvr
mvr
show mvr

mvr (Global Configuration)

This command enables Multicast VLAN Registration (MVR) globally on the switch,
statically configures MVR multicast group IP address(es) using the group keyword,
or specifies the MVR VLAN identifier using the vlan keyword. Use the no form of
this command without any keywords to globally disable MVR. Use the no form with
the group keyword to remove a specific address or range of addresses. Or use the
no form with the vlan keyword restore the default MVR VLAN.
Syntax
[no] mvr [group ip-address [count] | vlan vlan-id]
• ip-address - IP address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
• count - The number of contiguous MVR group addresses. (Range: 1-255)
• vlan-id - MVR VLAN ID (Range: 1-4094)
Default Setting
• MVR is disabled.
• No MVR group address is defined.
• The default number of contiguous addresses is 0.
• MVR VLAN ID is 1.
Command Mode
Global Configuration

Table 4-80 Multicast VLAN Registration Commands

Function
Globally enables MVR, statically configures MVR group
address(es), or specifies the MVR VLAN identifier
Configures an interface as an MVR receiver or source port,
enables immediate leave capability, or configures an
interface as a static member of the MVR VLAN
Shows information about the global MVR configuration
settings, the interfaces attached to the MVR VLAN, or the
multicast groups assigned to the MVR VLAN
www.digisol.com
DG-FS4526 User Manual
Mode
GC
IC
PE
4
Page
4-29
3
4-29
4
4-29
6
4-293