Show Mac-Address-Table Aging-Time; Lldp Commands - Digisol DG-FS4526 Management Manual

4
Command Line Interface
Example
Console(config)#mac-address-table aging-time 100
Console(config)#

show mac-address-table aging-time

This command shows the aging time for entries in the address table.
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show mac-address-table aging-time
Aging time: 100 sec.
Console#

LLDP Commands

Link Layer Discovery Protocol (LLDP) is used to discover basic information about
neighboring devices on the local broadcast domain. LLDP is a Layer 2 protocol that
uses periodic broadcasts to advertise information about the sending device.
Advertised information is represented in Type Length Value (TLV) format according
to the IEEE 802.1ab standard, and can include details such as device identification,
capabilities and configuration settings. LLDP also defines how to store and maintain
information gathered about the neighboring network nodes it discovers.
Link Layer Discovery Protocol - Media Endpoint Discovery (LLDP-MED) is an
extension of LLDP intended for managing endpoint devices such as Voice over IP
phones and network switches. The LLDP-MED TLVs advertise information such as
network policy, power, inventory, and device location details. The LLDP and
LLDP-MED information can be used by SNMP applications to simplify
troubleshooting, enhance network management, and maintain an accurate network
topology.
Command
lldp
lldp holdtime-multiplier
medFastStartCount
lldp notification-interval
lldp refresh-interval
4-178
Table 4-56 LLDP Commands
Function
Enables LLDP globally on the switch
Configures the time-to-live (TTL) value sent in LLDP
advertisements
Configures how many medFastStart packets are transmitted GC
Configures the allowed interval for sending SNMP
notifications about LLDP changes
Configures the periodic transmit interval for LLDP
advertisements
www.digisol.com
Mode Page
GC 4-180
GC 4-180
4-181
GC 4-181
GC 4-182