Link Aggregation Commands; Table 4-50 Link Aggregation Commands - Digisol DG-FS4526 Management Manual

Link Aggregation Commands

Ports can be statically grouped into an aggregate link (i.e., trunk) to increase the
bandwidth of a network connection or to ensure fault recovery. Or you can use the
Link Aggregation Control Protocol (LACP) to automatically negotiate a trunk link
between this switch and another network device. For static trunks, the switches have
to comply with the Cisco EtherChannel standard. For dynamic trunks, the switches
have to comply with LACP. This switch supports up to four trunks. For example, a
trunk consisting of two 1000 Mbps ports can support an aggregate bandwidth of
4 Gbps when operating at full duplex.
Command
Manual Configuration Commands
interface port-channel
channel-group
Dynamic Configuration Command
lacp
lacp system-priority
lacp admin-key
lacp admin-key
lacp port-priority
Trunk Status Display Command
show interfaces status
port-channel
show lacp
Table 4-50 Link Aggregation Commands
Function
Configures a trunk and enters interface
configuration mode for the trunk
Adds a port to a trunk
Configures LACP for the current interface
Configures a port's LACP system priority
Configures a port's administration key
Configures an port channel's administration key
Configures a port's LACP port priority
Shows trunk information
Shows LACP information
www.digisol.com
DG-FS4526 User Manual
Mode
GC
IC (Ethernet)
IC (Ethernet)
IC (Ethernet)
IC (Ethernet)
IC (Port Channel)
IC (Ethernet)
NE, PE
PE
4
Page
4-150
4-166
4-167
4-168
4-169
4-170
4-171
4-157
4-171
4-165