Table of Contents
Advertisement
Example
Console(config-if)#mac-authentication max-mac-count 32
Console(config-if)#
network-access dynamic-vlan
Use this command to enable dynamic VLAN assignment for an authenticated port.
Use the no form to disable dynamic VLAN assignment.
Syntax
[no] network-access dynamic-vlan
Default Setting
Enabled
Command Mode
Interface Configuration
Command Usage
• When enabled, the VLAN identifiers returned by the RADIUS server will be
applied to the port, providing the VLANs have already been created on the
switch. GVRP is not used to create the VLANs.
• The VLAN settings specified by the first authenticated MAC address are
implemented for a port. Other authenticated MAC addresses on the port must
have same VLAN configuration, or they are treated as authentication failure.
• If dynamic VLAN assignment is enabled on a port and the RADIUS server
returns no VLAN configuration, the authentication is still treated as a success.
• When the dynamic VLAN assignment status is changed on a port, all
authenticated addresses are cleared from the secure MAC address table.
Example
The following example enables dynamic VLAN assignment on port 1.
Console(config)#interface ethernet 1/1
Console(config-if)#network-access dynamic-vlan
Console(config-if)#
network-access guest-vlan
Use this command to assign all traffic on a port to a guest VLAN when network
access (MAC authentication) or 802.1x authentication is rejected. Use the no form
of this command to disable guest VLAN assignment.
Syntax
network-access guest-vlan vlan-id
no network-access guest-vlan
Default Setting
Disabled
www.digisol.com
DG-FS4526 User Manual
4
4-111
Hide quick links:
Advertisement
Table of Contents
