System Management Commands; Device Designation Commands; Prompt; Table 4-7 System Management Commands - Digisol DG-FS4526 Management Manual

4
Command Line Interface

System Management Commands

These commands are used to control system logs, passwords, user names, browser
configuration options, and display or configure a variety of other system information.
Command Group
Device Designation
Banner
User Access
IP Filter
Web Server
Telnet Server
Secure Shell
Event Logging
Time (System Clock)
System Status
Frame Size

Device Designation Commands

Command

prompt

hostname
snmp-server contact
snmp-server location
prompt
This command customizes the CLI prompt. Use the no form to restore the default
prompt.
Syntax
prompt string
no prompt
string - Any alphanumeric string to use for the CLI prompt. (Maximum
length: 255 characters)
Default Setting
Console
4-24

Table 4-7 System Management Commands

Function
Configures information that uniquely identifies this switch
Configures administrative contact and device indentification and location
information
Configures the basic user names and passwords for management access
Configures IP addresses that are allowed management access
Enables management access via a web browser
Enables management access via Telnet
Provides secure replacement for Telnet
Controls logging of error messages
Sets the system clock automatically via SNTP server or manually
Displays system configuration, active managers, and version information
Enables support for jumbo frames

Table 4-8 Device Designation Commands

Function
Customizes the prompt used in PE and NE mode
Specifies the host name for the switch
Sets the system contact string
Sets the system location string
www.digisol.com
Page
4-24
4-25
4-35
4-37
4-39
4-42
4-43
4-52
4-62
4-66
4-72
Mode Page
GC 4-24
GC 4-25
GC 4-136
GC 4-136