Mac Acls; Access-List Mac; Table 4-39 Mac Acl Commands - Digisol DG-FS4526 Management Manual

4
Command Line Interface

MAC ACLs

The commands in this section configure ACLs based on hardware addresses,
packet format, and Ethernet type. To configure MAC ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports
Command

access-list mac

permit, deny
show mac access-list
mac access-group
show mac access-group
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode.
Use the no form to remove the specified ACL.
Syntax
[no] access-list mac acl_name
acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• When you create a new ACL or enter configuration mode for an existing ACL,
use the permit or deny command to add new rules to the bottom of the list.
To create an ACL, you must add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed by the
exact text of a previously configured rule.
• An ACL can contain up to 32 rules.
Example
Console(config)#access-list mac jerry
Console(config-mac-acl)#
Related Commands
permit, deny (4-129)
mac access-group (4-131)
show mac access-list (4-130)
4-128

Table 4-39 MAC ACL Commands

Function
Creates a MAC ACL and enters configuration mode
Filters packets matching a specified source and
destination address, packet format, and Ethernet type
Displays the rules for configured MAC ACLs
Adds a port to a MAC ACL
Shows port assignments for MAC ACLs
www.digisol.com
Mode Page
GC 4-128
MAC-ACL 4-129
PE 4-130
IC 4-131
PE 4-131