Permit, Deny; Range - Digisol DG-FS4526 Management Manual

4
Command Line Interface
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#

permit, deny

This command sets the access mode for an IGMP filter profile. Use the no form to
delete a profile number.
Syntax
{permit | deny}
Default Setting
Deny
Command Mode
IGMP Profile Configuration
Command Usage
• Each profile has only one access mode; either permit or deny.
• When the access mode is set to permit, IGMP join reports are processed
when a multicast group falls within the controlled range. When the access
mode is set to deny, IGMP join reports are only processed when a multicast
group is not in the controlled range.
Example
Console(config)#ip igmp profile 19
Console(config-igmp-profile)#permit
Console(config-igmp-profile)#

range

This command specifies multicast group addresses for a profile. Use the no form to
delete addresses from a profile.
Syntax
[no] range low-ip-address [high-ip-address]
• low-ip-address - A valid IP address of a multicast group or start of a group
range.
• high-ip-address - A valid IP address for the end of a multicast group range.
Default Setting
None
Command Mode
IGMP Profile Configuration
Command Usage
4-288
www.digisol.com