Assigning Ports To Multicast Services; Figure 3-135 Ip Multicast Registration Table - Digisol DG-FS4526 Management Manual

3
Configuring the Switch
Web – Click IGMP Snooping, IP Multicast Registration Table. Select a VLAN ID and
the IP address for a multicast service from the scroll-down lists. The switch will
display all the interfaces that are propagating this multicast service.

Assigning Ports to Multicast Services

Multicast filtering can be dynamically configured using IGMP Snooping and IGMP
Query messages as described in "Configuring IGMP snooping and Query
Parameters" on page 3-133. For certain applications that require tighter control, you
may need to statically configure a multicast service on the switch. First add all the
ports attached to participating hosts to a common VLAN, and then assign the
multicast service to that VLAN group.
Command Usage
• Static multicast addresses are never aged out.
• When a multicast address is assigned to an interface in a specific VLAN, the
corresponding traffic can only be forwarded to ports within that VLAN.
Command Attributes
• Interface – Activates the Port or Trunk scroll down list.
• VLAN ID – Selects the VLAN to propagate all multicast traffic coming from the
attached multicast router/switch. (Range: 1-4094)
• Multicast IP – The IP address for a specific multicast service
• Port or Trunk – Specifies the interface attached to a multicast router/switch.
Web – Click IGMP Snooping, IGMP Member Port Table. Specify the interface
attached to a multicast service (via an IGMP-enabled switch or multicast router),
indicate the VLAN that will propagate the multicast service, specify the multicast IP
3-214

Figure 3-135 IP Multicast Registration Table

www.digisol.com