Lldp; Lldp Holdtime-Multiplier - Digisol DG-FS4526 Management Manual

4
Command Line Interface
Command
lldp medtlv
med-cap
lldp medtlv
network-policy
show lldp config
show lldp info
local-device
show lldp info
remote-device
show lldp info
statistics

lldp

This command enables LLDP globally on the switch. Use the no form to disable
LLDP.
Syntax
[no] lldp
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#lldp
Console(config)#

lldp holdtime-multiplier

This command configures the time-to-live (TTL) value sent in LLDP advertisements.
Use the no form to restore the default setting.
Syntax
lldp holdtime-multiplier value
no lldp holdtime-multiplier
value - Calculates the TTL in seconds based on
(holdtime-multiplier * refresh-interval) ≤ 65536
(Range: 2 - 10)
Default Setting
Holdtime multiplier: 4
TTL: 4*30 = 120 seconds
4-180
Table 4-56 LLDP Commands (Continued)
Function
Configures an LLDP-MED-enabled port to advertise its
Media Endpoint Device capabilities
Configures an LLDP-MED-enabled port to advertise its
network policy configuration
Shows LLDP configuration settings for all ports
Shows LLDP global and interface-specific configuration
settings for this device
Shows LLDP global and interface-specific configuration
settings for remote devices
Shows statistical counters for all LLDP-enabled interfaces
www.digisol.com
Mode Page
IC 4-194
IC 4-194
PE 4-195
PE 4-197
PE 4-198
PE 4-199