Figure 3-93 Configuring A Vlan Static Table - Digisol DG-FS4526 Management Manual

• Name – Name of the VLAN (1 to 32 characters).
• Status – Enables or disables the specified VLAN.
- Enable: VLAN is operational.
- Disable: VLAN is suspended; i.e., does not pass packets.
• Port – Port identifier.
• Membership Type – Select VLAN membership for each interface by marking the
appropriate radio button for a port or trunk:
- Tagged: Interface is a member of the VLAN. All packets transmitted by the port
will be tagged, that is, carry a tag and therefore carry VLAN or CoS information.
- Untagged: Interface is a member of the VLAN. All packets transmitted by the
port will be untagged, that is, not carry a tag and therefore not carry VLAN or
CoS information. Note that an interface can only have one untagged VLAN,
which must be the same as the Port VID. See
Interfaces" on page 3-153
- Forbidden: Interface is forbidden from automatically joining the VLAN via
GVRP. For more information, see "Automatic VLAN Registration" on page
3-145.
- None: Interface is not a member of the VLAN. Packets associated with this
VLAN will not be transmitted by the interface.
- Trunk Member – Indicates if a port is a member of a trunk. To add a trunk to the
selected VLAN, use the last table on the VLAN Static Table page.
Web – Click VLAN, 802.1Q VLAN, Static Table. Select a VLAN ID from the
scroll-down list. Modify the VLAN name and status if required. Select the
membership type by marking the appropriate radio button in the list of ports or
trunks. Click Apply.
for configuring PVID.

Figure 3-93 Configuring a VLAN Static Table

www.digisol.com
DG-FS4526 User Manual
"Configuring VLAN Behavior for
3
3-151