Configuring The Mac Authentication Reauthentication Time - Digisol DG-FS4526 Management Manual

The Network Access feature controls host access to the network by authenticating
its MAC address on the connected switch port. Traffic received from a specific MAC
address is forwarded by the switch only if the source MAC address is successfully
authenticated by a central RADIUS server. While authentication for a MAC address
is in progress, all traffic is blocked until authentication is completed. On successful
authentication, the RADIUS server may optionally assign VLAN settings for the
switch port
When enabled on a port interface, the authentication process sends a Password
Authentication Protocol (PAP) request to a configured RADIUS server. The
username and password are both equal to the MAC address being authenticated.
On the RADIUS server, PAP username and passwords must be configured in the
MAC address format XX-XX-XX-XX-XX-XX (all in upper case).
Authenticated MAC addresses are stored as dynamic entries in the switch secure
MAC address table and are removed when the aging time expires. The maximum
number of secure MAC addresses supported for the switch system is 1024.
Note:
MAC authentication cannot be configured on trunk ports.
The RADIUS server may optionally return a VLAN identifier list to be applied to the
switch port. The following attributes need to be configured on the RADIUS server.
• Tunnel-Type = VLAN
• Tunnel-Medium-Type = 802
• Tunnel-Private-Group-ID = 1u,2t
The VLAN identifier list is carried in the RADIUS "Tunnel-Private-Group-ID" attribute.
The VLAN list can contain multiple VLAN identifiers in the format "1u,2t,3u" where
"u" indicates an untagged VLAN and "t" a tagged VLAN.

Configuring the MAC Authentication Reauthentication Time

MAC address authentication is configured on a per-port basis, however there are
two configurable parameters that apply globally to all ports on the switch.
Command Attributes
• Authenticated Age – The secure MAC address table aging time. This parameter
setting is the same as switch MAC address table aging time and is only
configurable from the Address Table, Aging Time web page (see page 3-125).
(Default: 300 seconds)
• MAC Authentication Reauthentication Time – Sets the time period after which
a connected MAC address must be reauthenticated. When the reauthentication
time expires for a secure MAC address, it is reauthenticated with the RADIUS
server. During the reauthentication process traffic through the port remains
unaffected. (Default: 1800 seconds; Range: 120-1000000 seconds)
[VLAN ID list]
www.digisol.com
DG-FS4526 User Manual
3
3-85