Cluster Member - Digisol DG-FS4526 Management Manual

4
Command Line Interface
Command Mode
Global Configuration
Command Usage
• An "internal" IP address pool is used to assign IP addresses to Member
switches in the cluster. Internal cluster IP addresses are in the form
10.x.x.member-ID. Only the base IP address of the pool needs to be set since
Member IDs can only be between 1 and 36.
Set a Cluster IP Pool that does not conflict with addresses in the network IP
•
subnet. Cluster IP addresses are assigned to switches when they become
Members and are used for communication between Member switches and the
Commander
• You cannot change the cluster IP pool when the switch is currently in Commander
mode. Commander mode must first be disabled.
Example
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#

cluster member

This command configures a Candidate switch as a cluster Member. Use the no form
to remove a Member switch from the cluster.
Syntax
cluster member mac-address <mac-address> id <member-id>
no cluster member id <member-id>
mac-address - The MAC address of the Candidate switch.
member-id - The ID number to assign to the Member switch.
(Range: 1-36)
Default Setting
No Members
Command Mode
Global Configuration
Command Usage
• The maximum number of cluster Members is 36.
The maximum number of switch Candidates is 100
•
Example
Console(config)#cluster member mac-address 00-17-7c-0a-e2-f1 id 5
Console(config)#
4-316
.
www.digisol.com
.