Priority Commands (Layer 3 And 4); Map Ip Dscp; Table 4-69 Priority Commands (Layer 3 And 4) - Digisol DG-FS4526 Management Manual

Priority Commands (Layer 3 and 4)

Command

map ip dscp

map ip port
map ip precedence
map ip tos
map access-list ip
map access-list mac
show map ip dscp
show map ip port
show map ip precedence Shows the IP precedence map
show map ip tos
show map access-list
map ip dscp
This command enables and sets IP DSCP priority mapping (i.e., Differentiated
Services Code Point priority mapping). Use the no form to restore the defaults.
Syntax
map ip dscp [dscp-value cos cos-queue]
no map ip dscp [dscp-value]
• dscp-value - 8-bit DSCP value. (Range: 0-63)
• cos-queue - Port Class-of-Service queue. (Range: 0-3)
Default Setting
Status: Disabled
The DSCP default values are defined in the following table. Note that all the
DSCP values that are not specified are mapped to CoS queue 0.
Table 4-70
IP DSCP Value
0, 8
10, 12, 14, 16, 18, 20, 22, 24
26, 28, 30, 32, 34, 36, 38, 40, 42 2
46, 48, 56
Command Mode
Global Configuration
Table 4-69 Priority Commands (Layer 3 and 4)
Function
Configures IP DSCP to CoS queue mapping
Configures TCP port to CoS queue mapping
Configures IP precedence to CoS queue mapping
Configures IP ToS to CoS queue mapping
Sets the output queue for packets matching an IP ACL rule
Sets the output queue for packets matching a MAC ACL rule IC
Shows the IP DSCP map
Shows the IP port map
Shows the IP ToS map
Shows CoS value mapped to an access list for an interface
IP DSCP to CoS Queue
CoS Queue
0
1
3
www.digisol.com
DG-FS4526 User Manual
Mode
GC
GC
GC
GC
IC
PE
PE
PE
PE
PE
4
Page
4-253
4-254
4-259
4-259
4-257
4-257
4-258
4-258
4-259
4-259
4-260
4-253