Displaying Mvr Interface Status; Figure 3-140 Mvr Global Configuration - Digisol DG-FS4526 Management Manual

3
Configuring the Switch
• MVR Running Status – Indicates whether or not all necessary conditions in the
MVR environment are satisfied.
• MVR VLAN – Identifier of the VLAN that serves as the channel for streaming
multicast services using MVR. (Range: 1-4094; Default: 1)
• MVR Group IP – IP address for an MVR multicast group. The IP address range of
224.0.0.0 to 239.255.255.255 is used for multicast streams. MVR group addresses
cannot fall within the reserved IP multicast address range of 224.0.0.x. (Range:
224.0.1.0 - 239.255.255.255; Default: no groups are assigned to the MVR VLAN)
• Count – The number of contiguous MVR group addresses. (Range: 1-255;
Default: 0)
Web – Click MVR, Configuration. Enable MVR globally on the switch, select the
MVR VLAN, add the multicast groups that will stream traffic to attached hosts, and
then click Apply.
CLI – This example first enables IGMP snooping, enables MVR globally, and then
configures a range of MVR group addresses.
Console(config)#ip igmp snooping
Console(config)#mvr
Console(config)#mvr group 228.1.23.1 10
Console(config)#

Displaying MVR Interface Status

You can display information about the interfaces attached to the MVR VLAN.
Field Attributes
• Type – Shows the MVR port type.
• Oper Status – Shows the link status.
3-222

Figure 3-140 MVR Global Configuration

www.digisol.com
4-276
4-293
4-293