Sensor (Adf Width Aps 3) - Lexmark X862de Service Manual

7500-432, -632, and -832

Sensor (ADF width APS 3)

1.
Open the ADF left cover assembly.
2.
Lift the separation roll guide assembly to its uppermost position.
3.
Remove the actuator/media guide assembly. See
page 4-198.
4.
Remove the two screws securing the sensor mount (A) to the ADF.
5.
Slide the sensor mount (A) from the under of the ADF transport roll (B), and move it to the position in which
the required sensor is easily removed.
6.
Release the hook securing the sensor (ADF width APS 3) (C) to the sensor mount (A).
7.
Disconnect the connection from sensor (ADF width APS 3) (C).
8.
Remove the sensor (ADF width APS 3) (C).
The APS, pre-registration, and inverter sensors are removed in the same manner. Release the hook, disconnect
the connector, and remove the sensor.
A
A
4-194
MFP Service Manual
C
"Actuator/media guide assembly removal" on
B
Previous
Next
Go Back