7500-432, -632, and -832
Pick roll position motor assembly removal
1.
Open the ADF left cover assembly.
2.
Remove the ADF left cover media guide. See
3.
Remove the document set actuator. See
4.
Remove the screw from the green ground wire (A).
5.
Remove the screw securing the grounding plate (B).
6.
Remove the grounding plate (B).
7.
Remove the two screws securing the harness guide (C).
8.
Remove the harness guide (C).
9.
Disconnect the connector from the pick roll position motor assembly (D).
10.
Remove the one screw securing the pick roll position motor assembly (D).
11.
Remove the pick roll position motor assembly (D).
12.
Remove the harness from the harness guide (C).
4-190
MFP Service Manual
"ADF left cover media guide removal" on page
"" on page
4-187.
Connector
D
C
B
A
Previous
4-189.
Next
Go Back