Lexmark X862de Service Manual page 619

10.
Remove two E-clips with a prying tool securing the two small pulleys (F) on the rear of the frame assembly.
11.
Remove two small guides (G) and two small pulleys (F).
12.
Remove the tray 4 rear cables (D) from the bottom plate (H).
Note: Before re-installing:
–
It is recommended that all four cables be replaced.
–
Ensure tray 4 rear cables (D) are not twisted or kinked.
–
Route the cables properly as shown in the figure.
–
Replace the cables by setting the frame assembly on its side as shown in the figure.
7500-432, -632, and -832
4-239
Repair information
Previous
Next
Go Back