Media Transport Roll Assembly / Gear Removal - Lexmark X862de Service Manual

Media transport roll assembly / gear removal

1.
Remove the MPF rear cover. See
2.
Remove the MPF feed unit assembly. See
3.
Remove the printer left door assembly. See
4.
Open the printer left lower door assembly.
5.
Remove the two screws securing the tray 2 feed-out sensor guide (A).
6.
Remove the tray 2 feed-out sensor guide (A) while pulling on its center most point.
7.
Remove the e-clip with needle nose pliers on the front side securing the media transport roll (B).
8.
Remove the media transport roll assembly (B) by sliding it in the direction of the arrow and pulling out.
Note: When removing the media transport roll assembly (B), do not touch the rubber surface.
Note: When removing the media transport roll (B), the bushings and gear may become detached.
9.
Remove the media transport roll gear 18 tooth (C).
10.
Remove the transport roll rear bushing (D).
11.
Remove the transport roll front bushing (E).
D
Note: Before reinstalling the media transport roll assembly (B), do not touch the rubber surface.
"MPF rear cover removal" on page
"MPF feed unit assembly removal" on page
A
C
B
"Printer left door assembly removal" on page
E-clip
E
7500-432, -632, and -832
4-58.
4-54.
4-75.
Repair information
Previous
Next
Go Back
4-69