7500-432, -632, and -832
Hard drive removal
1.
Remove the rear RIP card cover. See
2.
Remove the RIP card chassis bracket. See
Warning: Do not drop the RIP card chassis bracket, or damage will occur.
3.
Remove the connector from the hard drive (A).
4.
Remove the two screws securing the hard drive (A) to the RIP card chassis bracket (B).
5.
Pull the hard drive (A) to release the three locator snaps.
6.
Remove the hard drive (A).
Warning: Do not drop the hard drive, or damage will occur.
A
B
4-128
MFP Service Manual
"Rear RIP card cover removal" on page
"RIP card chassis bracket removal" on page
connector
4-13.
4-127.
Previous
Next
Go Back