Adf Media Feed Assembly Removal - Lexmark X862de Service Manual

7500-432, -632, and -832

ADF media feed assembly removal

1.
Remove the ADF unit assembly. See
2.
Remove the ADF front cover assembly. See
3.
Remove the ADF rear cover. See
4.
Remove the ADF left cover assembly. See
5.
Remove the document tray assembly. See
6.
Disconnect connectors P754, P755, P758, P761, P785, and P786 from the ADF controller card assembly
(A).
7.
Loosen the set screw securing the damper (B) with an Allen wrench.
8.
Remove the damper (B).
9.
Disconnect the two connections from the switch (ADF left cover interlock) (D) with needle nose pliers.
10.
Disconnect the connector from the document set LED (E).
11.
Disconnect the connector from the inverter solenoid assembly (F).
12.
Release the harness from the three clamps.
13.
Remove the two front screws and the five rear screws securing the ADF media feed assembly (G) to the
ADF.
14.
Release the two harness from the clamp molded into the base of the ADF.
Note: The above clamp is located beneath the ADF registration motor. Do not excessively bend the clamp
or it may break.
4-170
MFP Service Manual
"ADF unit assembly removal" on page
"ADF front cover assembly removal" on page
"ADF rear cover removal" on page
"ADF left cover assembly removal" on page
"Document tray assembly removal" on page
4-167.
4-174.
4-173.
4-176.
4-172.
Previous
Next
Go Back