7500-432, -632, and -832
MPF feed unit assembly removal
1.
Remove the MPF rear cover.
2.
Disconnect the connector.
3.
Release the harness from the clamp.
4.
Remove the two screws securing the MPF feed unit assembly (A).
5.
Remove the MPF feed unit assembly (A).
Note: Before reinstalling, place the harness along the slot on the left of the MPF feed unit assembly (A) so it
does not pinch the harness between the feed unit.
4-54
MFP Service Manual
"MPF rear cover removal" on page
Clamp
Left
4-58.
A
Previous
Next
Go Back