Adf Left Cover Assembly Removal - Lexmark X862de Service Manual

7500-432, -632, and -832

ADF left cover assembly removal

1.
Open the ADF left cover assembly.
2.
Remove the ADF front cover assembly. See
3.
Remove the ADF rear cover. See
4.
Remove the ADF left cover media guide. See
5.
Remove the screw securing the harness retainer (A).
6.
Remove the harness retainer (A).
7.
Remove the screw securing the left cover hinge retainer (B).
8.
Remove the left cover hinge retainer (B).
9.
Remove the screw securing the front hinge pin (C).
10.
Remove the front hinge pin (C).
11.
While holding the ADF left cover assembly, remove the rear hinge pin with needle nose pliers (D), and
remove the ADF left cover assembly (E) from the ADF.
Warning: Do not allow the ADF left cover assembly (E) to hang by the harness, or damage will occur.
12.
Remove the left cover pinch roll assembly. See
page 4-179.
13.
Disconnect the connector from the sensor (pick roll position HP) (F) located on the ADF left cover
assembly (E).
14.
Remove the screw from the green ground wire (G).
15.
Remove the screw securing the grounding plate (H).
16.
Remove the grounding plate (H).
17.
Remove the two screws securing the harness guide (I).
18.
Detach the harness guide (I).
19.
Disconnect the connector from the pick roll position motor assembly (J).
4-176
MFP Service Manual
"ADF front cover assembly removal" on page
"ADF rear cover removal" on page
"ADF left cover media guide removal" on page
"Left cover pinch roll assembly removal" on
4-174.
4-173.
4-189.
Previous
Next
Go Back