Sensor (Tray 3 Feed-Out) Static Jam - Lexmark X862de Service Manual

Step
9 Check the sensor (tray 3 feed-out) for proper
connection.
Is the above sensor connected properly?
10 Check the connection between the 2TM/TTM controller
card assembly and the printer engine card assembly.
Are the above boards connected properly?
11 Perform a print test.
Does the error still occur?
12 Perform a print test.
Does the error still occur?

243.04 Sensor (tray 3 feed-out) static jam

Step
1 Check the media position.
Does the media touch the sensor (tray 3 feed-out)?
Open the 2TM/TTM left door assembly, and visually
check it.
2 Check the sensor (tray 3 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor Test.
4. Touch Tray 3.
5. Touch Feed-out.
Open the 2TM/TTM left door assembly, and visually
check it.
Does the display on the operator panel change every
time the actuator on the above sensor operates?
Check
Check
7500-432, -632, and -832
Yes
Replace the sensor Replace the
(tray 3 feed-out). connection.
Go to "2000-sheet
dual input (TTM)—
sensor (tray 3 feed-
out) removal" on
page 4-254.
Go to step 11. Replace the
connection.
Replace the 2TM/ Problem solved.
TTM controller card
assembly.
Go to "2000-sheet
dual input (TTM)—
2TM/TTM controller
card assembly
removal" on
page 4-281.
Go to step 12.
Replace the printer Problem solved.
engine card
assembly.
Go to "Printer
engine card
assembly removal"
on page 4-119.
Yes
Remove the media. Go to step 2.
Go to step 4. Go to step 3.
Diagnostic information
Previous
No
Next
Go Back
No
2-69