Lexmark X862de Service Manual page 132

7500-432, -632, and -832
Error code or
message
984.00
Service
finisher error
984.01
Service
finisher error
985.00
Service
finisher error
985.01
Service
finisher error
986.00
Service
finisher error
986.01
Service
finisher error
987.00
Service
finisher error
987.01
Service
finisher error
988.00
Service
finisher error
988.01
Service
finisher error
2-32
MFP Service Manual
Error contents
Sensor (punch unit HP) on
failure
Sensor (punch unit HP) off
failure
Sensor (punch carriage shift
HP) on failure
Sensor (punch carriage shift
HP) off failure
Sensor (eject clamp HP) on
failure
Sensor (eject clamp HP) off
failure
Sensor (media eject shaft
HP) on failure
Sensor (media eject shaft
HP) off failure
Sensor (punch unit side
reg 1) on failure
Sensor (punch unit side
reg 2) on failure
Sensor (punch unit side
reg 1) off failure
Sensor (punch unit side
reg 2) off failure
Description/Action
The sensor (punch unit HP) is not turned on even
when the specified time passed after the punch unit
motor is turned on.
Refer to the Options Service Manual.
The sensor (punch unit HP) is not turned off even
when the specified time passed after the punch unit
motor is turned on.
Refer to the Options Service Manual.
The sensor (punch carriage shift HP) is not turned
on even when the specified time passed after the
punch carriage shift motor assembly is turned on.
Or the sensor (punch carriage shift HP) is turned off
again after the sensor (punch carriage shift HP) is
turned on and the punch carriage shift motor
assembly stopped its rotation.
Refer to the Options Service Manual.
The sensor (punch carriage shift HP) is not turned
off even when the specified time passed after the
punch carriage shift motor assembly is turned on.
Or the sensor (punch carriage shift HP) is turned on
again after the sensor (punch carriage shift HP) is
turned off and the punch carriage shift motor
assembly stopped its rotation.
Refer to the Options Service Manual.
The sensor (eject clamp HP) is not turned on within
500 ms after the eject clamp up starts.
Refer to the Options Service Manual.
The sensor (eject clamp HP) is not turned off within
200 ms after the eject clamp down starts.
Refer to the Options Service Manual.
The sensor (media eject shaft HP) is not turned on
within 200 ms after the set clamp starts operating.
Refer to the Options Service Manual.
The sensor (media eject shaft HP) is not turned off
within the specified time after the set clamp ends
operating.
Refer to the Options Service Manual.
The sensor (punch unit side reg 1) or sensor (punch
unit side reg 2) did not detect the media correctly or
is defective.
Refer to the Options Service Manual.
The sensor (punch unit side reg 1) or sensor (punch
unit side reg 2) did not detect the media correctly or
is defective.
Refer to the Options Service Manual.
Previous
Next
Go Back