7558-xxx
Step
Action and questions
POR the machine, and perform a
8
print test. Go to
"PRINT TESTS"
on page
3-26.
Does the error continue?
242.01 Sensor (tray 2 feed out) static jam
Step
Action and questions
Check the media path.
1
Is the media path free of any
media fragments?
Check the sensor (tray 2 feed
2
out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch SENSOR TESTS.
3. Touch PRINTER SENSOR
TESTS.
4. Touch Sensor (tray 2 feed
out).
Does the display on the
operator panel change every
time the sensing area of the
above sensor is interrupted or
blocked?
Check the sensor (tray 2 feed
3
out) for proper connection.
Is the above component
properly connected?
Check the connection between
4
the lower engine PCBA and the
tray module controller PCBA.
Are the above components
properly connected?
POR the machine, and perform a
5
print test. Go to
"PRINT TESTS"
on page
3-26.
Does the error continue?
POR the machine, and perform a
6
print test. Go to
"PRINT TESTS"
on page
3-26.
Does the error continue?
Service Manual
2-118
Yes
Replace the upper printer engine
PCBA.
Go to
"Upper printer engine
PCBA removal" on page
4-189.
Yes
Go to step 2.
Go to step 4.
Clean or replace the sensor (tray
2 feed out). Go to
"Sensor (tray
module feedout) removal" on
page
4-276.
Replace the tray module
controller PCBA.
Go to
"Tray module controller
PCBA removal" on page
4-282.
If the problem remains go to step
5.
Replace the lower engine PCBA.
Go to
"Lower engine PCBA
removal" on page
4-106.
Replace the upper printer engine
PCBA.
Go to
"Upper printer engine
PCBA removal" on page
4-189.
No
Problem resolved
No
Remove any media or media
fragments.
Go to step 3.
Replace the connection.
Replace the connections.
Problem resolved
Problem resolved
Previous
Next
Go Back