Sensor (Standard Media Bin Full) Removal; Media Feed Unit Assembly 1 Removal - Lexmark X940e Service Manual

Sensor (standard media bin full) removal

1. Remove the rear cover assembly. See
Warning: Ensure that the rear left middle cover is removed before removing the rear left upper cover, or damage
will occur.
2. Remove the rear left middle cover. See
3. Remove the rear left upper cover. See
4. Remove the standard media exit bin full actuator. See
page 4-18.
5. Remove the screw securing the bracket (A) to the machine.
6. Remove the bracket (A).
7. Release the hooks securing the sensor (standard bin full) (B) to the bracket (A).
8. Remove the sensor (standard bin full) (B).
9. Disconnect the connector from the sensor (standard media bin full) (B).

Media feed unit assembly 1 removal

1. Remove the media tray 1.
2. Remove the printer left lower door assembly. See
3. Disconnect the connector from the media feed unit assembly (A).
4. Remove the two screws securing the media feed unit assembly (A) to the machine.
5. Remove the media feed unit assembly (A).
"Rear cover assembly removal" on page
"Rear left middle cover removal" on page
"Rear left upper cover removal" on page
"Standard media exit bin full actuator removal" on
B
"Printer left lower door assembly removal" on page
Connector
Clamp
A
4-5.
4-7.
A
Repair information
7510-XXX
4-6.
4-8.
4-21